You are here: Home :: Area NEM :: Agricultural science

N. Terziev

Industrial Kiln Drying and its Effect on Microstructure, Impregnation and Properties of Scots Pine Timber Impregnated for Above Ground Use. Part 1. Effects of Initial, Final Dryings and Preservative on Impregnation and Timber Quality

Scots pine (Pinus sylvestris L.) planks were dried in industrial progressive, conventional batch and high temperature kilns. The quality of drying was assessed by measuring the final moisture content and its gradient, deformations, checks and internal stress of planks. The timber was rearranged in three charges and impregnated in an industrial autoclave with copper-based preservatives for above ground use (class AB):Kemwood ACQ 1900, Tanalith E and Wolmanit CX-8. The moisture content was determined after impregnation and the planks were divided into two charges; the first was dried in an industrial conventional batch kiln while the second was air dried. Assessment of the final product quality after kiln and air drying was carried out as after the initial drying. The penetration of preservatives was measured as well. The data were analysed by a statistical mixed model to ascertain the effects of drying and preservatives on the impregnation and timber quality.

A strong relationship was found between the initial drying of Scots pine timber and its quality after impregnation and drying. The conventional batch and high temperature kiln drying ensured similar drying quality regarding the final moisture content and gradient, bow, twist and checks, but the high temperature drying provided significantly better (94.4%of the total sapwood area) penetration of the preservatives tested. It is suggested that changes in wood structure could be provoked during the high temperature drying, thus improving the subsequent impregnation and secondary drying. The progressive and conventional batch kiln drying led to similar penetration of the preservatives; the conventional batch kiln drying ensured significantly lower final moisture content, less twist and surface checks of the timber than the progressive kiln drying. Wolmanit CX-8 penetrated significantly better into the pine sapwood (96.3%) than Kemwood ACQ 1900 and Tanalith E (83.5 and 88.5%, respectively). The planks impregnated with Wolmanit CX-8 achieved the best quality regarding the final moisture content, its gradient and cup. The planks impregnated with Kemwood ACQ 1900 and Tanalith E showed similar quality regarding the penetration and some deformations after drying, but Kemwood ACQ 1900 impregnated planks had highest moisture content and gradient.

Holzforschung, Walter de Gruyter

Print ISSN: 0018-3830
Volume: 56, 06/2002
Pages: 428 - 433

Show full article (external site)

Show all available items of this journal

 

Area NEM